-Ensure that the air valve pin is in the upright position before inflating. Also, verify that the hose is securely connected to the inflation port of the pump；

-For maximum efficiency, utilize the dual-action mode during the initial stages of inflation;

-The pressure gauge is sensitive and will indicate 1 PSI increments. The board will reach its full shape at this initial pressure;

-Once reaches approximately 7 PSI, switch to single-action mode for labor saving. Recommended pressure: 12-15 PSI.

-The recommended air pressure for inflatable seats is 5-8 PSI.

-The back of the chair is padded and designed for optimal comfort when leaning.

-Adjust the length of the ropes to alter the angle of the seat, thus increasing comfort and support.

-Before turning the tension lever, ensure pull out the inner shaft first. Avoid overturning the tension lever as this can cause the tension mechanism to break;

-Ensure the correct orientation of the handle and blade. The design is ergonomic, so feel the difference in handling with various orientations;

- It's recommended that the paddle height is 4” to 6” higher than head;

- The fully assembled paddle is buoyant and can float for at least one hour. However, the single middle shaft is not buoyant

-When falling off the board, the water flow and the natural force of the fall can push the board away from you;

-Always remember to attach the leash to the board and your ankle or wrist. It can be a lifesaver in case you fall off the board unexpectedly;

-The leash we provide is 10 feet long, constructed with a 7mm cord TPU line and SUS swivels on both ends. It is one of the best leashes on the market, offering superior strength, reliability, and comfort.

-Rotate the tube as needed for easier and more convenient insertion.

-Ensure that one end of the tube is slightly longer than the other.

-Insert the longer end of the tube first, then install the other end.

-Finish it.

-Position the bag to ensure that the mobile phone camera is easily accessible for convenient shooting;

-Ensure that the inner seal is securely and completely closed;

-Align the Velcro closures to ensure a secure and tight fit.